![]() ![]() The back of the rail should be flush with the back of the trim and inside of the feet. Attach the rails to the trim and feet with 2 1/2″ pocket hole screws and wood glue. Step 5:Ĭut the side rails to size and drill 1 1/2″ pocket hole screws along one edge and both ends. Attach the trim to the foot with 2 1/2″ pocket hole screws and wood glue. Step 4:Ĭut the side trim pieces to size and drill 1 1/2″ pocket holes at both ends. The back of the rail should be flush with the back of the trim. Attach it to the trim and feet with 2 1/2″ pocket hole screws and wood glue. Step 3:Ĭut the footboard rail to size and drill 1 1/2″ pocket holes along one edge and both ends. I used a few clamps to keep the joints flush while I attached them. The front and top of the trim should be flush with the front and top of the feet. Attach it to the feet with 2 1/2″ pocket hole screws and wood glue. Step 2:Ĭut the footboard trim to size and drill 1 1/2″ pocket holes at both ends. Building the Wooden Bed Frame Step 1: Foot AssembliesĬut the foot pieces to size and stack two pieces together with 2″ brad nails and wood glue. This is what the hardwood headboard should look like now. Attach it to the headboard legs with 2 1/2″ pocket hole screws and wood glue. Step 4:Ĭut the headboard stretcher to size and drill 1 1/2″ pocket holes at both ends. This is what your headboard should look like at this point. You can find the right angle clamp we use here.It holds the boards in place while you are attaching through other pocket holes. I like to use the Kreg Right Angle Clamp to start. The back and top of the planks should be flush with the back and top of the legs. Attach them with wood glue and 2″ brad nails.Īttach each leg assembly to the headboard planks with 1 1/4″ pocket hole screws and wood glue. Step 2:Ĭut the leg pieces to size and stack two legs on each other. ![]() You can find our favorite Kreg Jig model hereĪttach the planks together with 1 1/4″ pocket hole screws.I used our favorite Kreg Jig model to make my pocket holes. Tools:īuilding the Headboard Step 1: Kreg Jig 720ProĬut the planks to size and drilled 3/4″ pocket holes according to the cut list. This set of plans is designed for a full size mattress. How to Build a DIY Wood Bed Frame and Headboard Check out some of the other bed frame project we’ve designed!.How to Build a DIY Wood Bed Frame and Headboard. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |